Mounting
5.5 Mounting with mounting plate
5.5.5
Fitting the mounting plate to a mast
Procedure
Figure 5-11
Follow the steps below to fit the mounting plate to a mast:
1. Feed the fastening straps through the openings in the mounting plate (position A in the
figure above).
2. Place the fastening straps around the mast at the required position.
3. Feed the free end of the strap through the quick-release fastener. You can twist the
tensioning screw (position B in the figure above) to the side to adapt a fastening strap to
the diameter of the mast.
4. Press the tensioning screw against the fastening strap and tighten the tensioning screw,
tightening torque 4.5 Nm.
30
Mounting plate with fittings for mast mounting
Operating Instructions, 11/2014, A5E03678337-07
SCALANCE W786-x