Troubleshooting; Technical Characteristics - LAVAZZA LB 1200 GALACTICA Instructions For Use Manual

Problem encountered
The machine does not turn on.
The pilot lights are blinking at a fast rate
or the following symbol appears on the
display:
The capsule-loading lever will not close
properly.
The pump does not start.
The machine does not brew espresso.
The espresso is not hot enough.
The espresso spurts out too quickly, and
cream does not form in espresso drinks.
Latte or cappuccino froth is not produced.
Latte or cappuccino froth is not produced.
No steam is dispensed from the mixer.
For any other types of failure not described in the above table or in cases where the suggested solutions do
not solve the problem, contact a Lavazza customer-assistance centre.
The technical characteristics are illustrated on the nameplate/data label attached to the machine itself.
· Voltage: 220-240 V / 50-60 Hz
· Rated power: 1000 W
· Tank capacity: 3 l
· Weight: 8,7 kg

TROUBLESHOOTING

Possible causes
»
The machine is not connected to the mains
power supply.
» A failure has occurred.
»
The used capsule or drip tray is full.
»
Capsule inserted incorrectly.
»
There is no water in the tank.
» Capsule not inserted.
»
Operating temperature has not been reached.
» Capsule-loading lever is raised.
»
No water in the tank.
»
Filter not inserted correctly.
»
The cups are cold.
» A used capsule has been inserted.
»
The milk is not cold enough.
»
The milk frother tube is obstructed.
» The milk frother does not rotate.
» The milk frother tube is obstructed.
»
No water in the tank.
»
Filter not inserted correctly.

TECHNICAL CHARACTERISTICS

Solution
»
Make sure the plugs are inserted properly.
» Contact the customer-assistance service/centre.
»
Empty the used capsule or drip tray.
»
Raise the capsule-loading lever and insert the capsule
correctly.
»
Top up with fresh, drinking water and repeat the hydrau-
lic circuit washing operation.
» Insert a capsule.
»
Wait until the correct temperature has been reached.
» Lower the capsule-loading lever.
»
Top up with fresh drinking water and repeat loading of
the hydraulic circuit.
» Check insertion of the Brita® filter and repeat loading
of the hydraulic circuit (see the instructions provided
with the filter).
»
Preheat the cups, filling them with warm water.
» Insert a new capsule.
»
Use milk at refrigerator temperature.
»
Carry out automatic cleaning of the mixer; if necessary,
extract the milk frother rod, check whether it is dam-
aged and perform cleaning manually. If the problem
cannot be solved, contact a service centre.
» Carry out automatic cleaning of the mixer; if necessary,
extract the milk frother rod, check whether it is dam-
aged and perform cleaning manually. If the problem
cannot be solved, contact a service centre.
» Carry out automatic cleaning of the mixer. If the prob-
lem cannot be solved, contact a service centre.
»
Top up with fresh drinking water and repeat loading of
the hydraulic circuit.
»
Check insertion of the Brita® filter and repeat loading
of the hydraulic circuit (see the instructions provided
with the filter).
· Materials used in housing and frame: thermoplastic
· Size: Height 36,5 cm - Length 36,5 cm - Depth 29,0 cm
2006/42 CE – 2004/108 CE – 2006 /95 CE
E N
27