Table of Contents
Advertisement
Chapter 2 Installation of FNS-7000A
2.1
Network Configuration
By factory default, FNS-7000A will search the network via DHCP (Dynamic Host
Configuration Protocol) to detect IP address settings automatically. If your
network does not support DHCP protocol, FNS-7000A will use the default settings
as below:
IP Address: 192.168.0.1
Subnet Mask: 255.255.255.0
When FNS-7000A completes its boot-up process, the LCD panel will display
current IP address settings.
If your network does not support DHCP protocol, you must configure your FNS-
7000A to proper LAN settings before using it for the first time. (If you are not
sure about the LAN settings, please contact your network administrator).
You can change the network settings of FNS-7000A by the following ways:
1. Use the LCD panel to change the network settings. For more information,
please refer to Appendix A.
2. Use Quick Install Wizard in the companion CD to change the network settings.
For more information, please refer to Appendix C.
7
Advertisement
Table of Contents
