Toyota 4runner 2009 Owner's Manual page 445

4RUNNER_U.book Page 450 Wednesday, July 30, 2008 3:00 PM
5-2. Steps to take in an emergency
Front
450
4RUNNER_U_(L/O_0808)
Position the jack at the correct
jack point as shown.
Front
Rear
Make sure the jack is positioned
on a level and solid place.
Assemble the jack handle exten-
sion as shown. Be sure to tighten
each bolt securely.
When connecting the jack han-
dle extension(s) and jack handle
end, use the jack handle to
tighten the square head bolt.
Make sure that the bolt fits into
the depression on the joint.
When connecting the jack han-
dle extension with the jack han-
dle, tighten the round head bolt
by hand.
Raise the vehicle until the tire is
slightly raised off the ground.
When positioning the jack under
the rear axle housing, make
sure the groove on the top of
the jack fits with the rear axle
housing.