Xerox Phaser 4510 User Manual page 135

Maintenance Safety
■
■
■
Operational Safety
Your printer and supplies were designed and tested to meet strict safety requirements. These
include safety agency examination, approval, and compliance with established environmental
standards.Your attention to the following safety guidelines helps to ensure the continued, safe
operation of your printer.
Printer Location
Place the printer in a dust-free area within a temperature range of 41° F to 95° F (5° C to
35° C) and a relative humidity range of 15 percent to 85 percent.
Humidity should be 70 percent or below at 90° F, and temperature should be 82° F or below at
85 percent humidity.
Note:
can cause condensation inside the machine, directly interfering with image transfer.
Printer Clearance
Place the printer in an area where there is adequate space for ventilation, operation, and
servicing. The recommended minimal spacing is:
Overhead Clearance:
■
Total Height Requirements:
■
Other Clearances:
■
■
■
■
Downloaded From ManualsPrinter.com Manuals
Do not attempt any maintenance procedure that is not specifically described in the
documentation supplied with your printer.
Do not use aerosol cleaners. The use of supplies that are not approved may cause poor
performance and could create a hazardous condition.
Do not attempt to open, reuse, or burn any consumables or routine maintenance items. For
information on Xerox supplies recycling programs, go to www.xerox.com/gwa.
Sudden temperature fluctuations can affect print quality. Rapid heating of a cold room
400 mm (16 in.) above the printer
Printer: 820 mm (32 in.)
109 mm (4.3 in.) behind the printer
480 mm (19 in.) in front of the printer
210 mm (8 in.) on the left side of the printer
300 mm (12 in.) on the right side of the printer
Phaser® 4510 Laser Printer
A-3