Troubleshooting Guide; Tool Specifications - Stanley FMFP12704 Operation And Maintenance Manual

MANY COMMON PROBLEMS CAN BE SOLVED EASILY BY UTILIZING THE CHART
BELOW. FOR MORE SERIOUS OR PERSISTENT PROBLEMS, CONTACT A STANLEY
BLACK & DECKER SERVICE CENTER OR CALL 1 888 848-5175.
To reduce the risk of serious personal injury, ALWAYS
disconnect air from tool before all repairs.
SYMPTOM
Air leak near
top of tool or in
trigger area
Tool does nothing
or operates
sluggishly
Air leak near
bottom of tool
Tool jams
frequently
Other
Height (inch/mm)
Width (inch/mm)
Length (inch/mm)
Weight (lbs/kg)
Recommended
Operating Pressure
Air Consumption per 100 cycles 4.13 CFM
Loading capacity

TROUBLESHOOTING GUIDE

PROBLEMS
Loose screws.
Worn or damaged
o-rings or seals.
Inadequate air supply.
Inadequate lubrication.
Worn or damaged
o-rings or seals.
Loose screws.
Worn or damaged
o-rings or bumper.
Incorrect fasteners.
Damaged fasteners.
Bent collation wire.
Canister or nose
screws loose
Canister is dirty.
Driver tip is worn
or damaged.

TOOL SPECIFICATIONS

14 - ENG
SOLUTIONS
Tighten screws.
Install Overhaul Kit.
Verify adequate air supply.
Put 5 or 7 drops of
oil into air inlet.
Install Overhaul Kit.
Tighten screws.
Install Overhaul Kit.
Verify approved fasteners
of correct size and 15°
collation angle.
Replace with undamaged
fasteners.
Tighten screws.
Clean magazine.
Install Driver
Maintenance Kit.
Contact a STANLEY
Authorized Warranty
Service Center
FMFP12704
10.5 / 266.7
4 / 101.6
10.5 / 266.7
4.37 / 1.98
70-120 psi (4.8 to 8.3 bar)
120 nails