Midi Cc Value Increment/Decrement - M-Audio code25 User Manual

MIDI CC Value Increment/Decrement

You can set a button to increment/decrement a MIDI CC value by 1 each time you press it.
After it reaches its highest or lowest value, it will "wrap around" and start again at its lowest or
highest value, respectively. In other words, pressing the button causes the value to cycle
through its entire range by increments of 1.
The buttons must be in MIDI Mode to do this (see
Important: Each button with this type of assignment is independent of the others. If you set
one button to increment a value and another button to decrement the same value, they will
each be sending different values, not resuming where the other button left off.
For example, pressing an "increment" button would cause a MIDI CC value to become 1, 2, 3,
etc., but pressing a "decrement" button for the same MIDI CC would cause it to become 127,
126, 125, etc.
To assign a button to increment/decrement a MIDI CC value:
1. Press Edit to enter Edit Mode. The Edit button will light up.
2. Press the desired button. The button's number will appear in the display.
3. Press the Ctrl Assign key. The display will show ASGN for 1 second and then show the
button's number (B__) and a number for the type of message it sends.
4. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter 154 (to increment a
MIDI CC value) or 153 (to decrement a MIDI CC value).
5. Press the Data 1 key. The display will show DATA1 for 1 second and then show the
button's number (B__) and the MIDI CC value it will increment/decrement.
6. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a value (000–127).
7. Press the Data 2 key. The display will show DATA2 for 1 second and then show the
button's number (B__) and the lowest value it will send.
8. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a value (000–127).
9. Press the Data 3 key. The display will show DATA3 for 1 second and then show the
button's number (B__) and the highest value it will send.
10. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a value (000–127).
11. Press the Enter key. The button is now set to increment/decrement the assigned MIDI CC
value, and you will exit Edit Mode.
To cancel your changes instead, press Edit. You will exit Edit Mode without saving anything.
Remember to store the preset if you want to save your changes in that preset.
Modes > MIDI Mode).
49