Chan Assign; Prog; Snap Shot; Bank Lsb / Bank Msb - M-Audio code25 User Manual

Chan Assign

Press this key to view or enter the MIDI channel (using the numeric keys (0–9)) for the currently
selected control. The control will send its MIDI messages over this MIDI channel.
When assigning the MIDI channel for a control, you can select one of the standard MIDI
channels (00–16), Code 61's global MIDI channel (00), or one of Values 17–20, which
correspond to channels used by Zones 1–4 (z1–z4). Instead of selecting a specific channel,
you can assign the control to a zone channel.
To learn how to set the MIDI channel for a specific control, see one of the sections below:
Faders > Editing Assignments > Channel
Buttons > Editing Assignments > Channel
Encoders > Editing Assignments > Channel
X-Y Pad > Editing Assignments > Channel
Pads > Editing Assignments > Channel
Wheels > Editing Assignments > Channel
Sustain Pedal > Editing Assignments > Channel
Volume Pedal > Editing Assignments > Channel
To learn how to set the MIDI channel for an entire zone, see

Prog

Press this key to enter a program change number (using the numeric keys (0–9)) and send it
over the global MIDI channel.
Alternatively, press and hold Shift and then press one of the Preset Down/Up () buttons.
To learn how to send program change messages, see the

Snap Shot

Press this key to send out the assigned MIDI message and current position/value of all
controls. This ensures that your software or other MIDI device matches the current
positions/values of all controls on your Code Series keyboard.
Tip: Alternatively, press Shift and Channel simultaneously.

Bank LSB / Bank MSB

Use these keys to send bank change messages (Bank LSB and Bank MSB) over the current
MIDI channel. These messages are used to access additional banks of presets on virtual
instruments, MIDI sound modules, etc. (if available).
To learn how to send bank change messages, see the
Note: A Bank LSB or Bank MSB number may not have any effect until you send a program
change message after it. See Program Changes
Channels > Zone
Program Changes
Bank Changes
to learn how to do this.
Channel.
chapter.
chapter.
38