Program Increment/Decrement - M-Audio code25 User Manual

Program Increment/Decrement

You can set the sustain pedal to increment/decrement the program number by 1 each time
you press it. After it reaches its highest or lowest program, it will "wrap around" and start
again at its lowest or highest program, respectively. In other words, pressing the sustain pedal
causes the value to cycle through its entire range by increments of 1.
To assign the sustain pedal to increment/decrement the program number:
1. Press Edit to enter Edit Mode. The Edit button will light up.
2. Press the sustain pedal. The button's number will appear in the display.
3. Press the Ctrl Assign key. The display will show ASGN for 1 second and then show SUS
and a number for the type of message it sends.
4. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter 156 (to increment
the program number) or 155 (to decrement the program number).
5. Press the Data 2 key. The display will show DATA2 for 1 second and then show SUS and
the lowest program number it will send.
6. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a value (000–127).
7. Press the Data 3 key. The display will show DATA3 for 1 second and then show SUS and
the highest program number it will send.
8. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a value (000–127).
9. Press the Enter key. The sustain pedal is now set to increment/decrement the program
number, and you will exit Edit Mode.
To cancel your changes instead, press Edit. You will exit Edit Mode without saving anything.
Remember to store the preset if you want to save your changes in that preset.
91