Rotary Knobs And Buttons; Switching On And Off; Adjusting The Base Volume; Infotainment Buttons - Seat ibiza Owner's Manual

Lightly pressing the buttons or briefly
●
pressing the touchscreen is sufficient to op-
erate the unit.
It is possible that not all the functions and
●
function buttons are available as the software
of the unit responds to the specific character-
istics of each market. A missing function but-
ton on the screen is not the result of an error
in the unit.
Due to country-specific legislation, certain
●
functions cannot be selected on the screen
when the vehicle is travelling above a certain
speed.
● Using a mobile telephone inside the vehicle
can cause noise in the speakers.
There may be restrictions on the use of
●
Bluetooth devices in some countries. Infor-
mation is available from the local authorities.
In some vehicles equipped with a parking
●
distance warning system, the volume of the
audio source is automatically lowered when
the gear is engaged.
● If the steering wheel has a voice control
button , it will not work in this radio mod-
el, so it has no function in relation to the ra-
dio.
Introduction

Rotary knobs and buttons

Rotary knobs
›››
The left-hand rotary knob Fig.
›››
Fig. 2 is used as the volume control 
8
or on/off button.
›››
The right-hand rotary knob Fig.
›››
Fig. 2 is used as the setup button.
10

Infotainment buttons

In these instructions, the unit buttons are de-
picted by the word "infotainment button"
and their function is shown inside a rectan-
gle (for example: infotainment button
››› ›››
Fig. 1, Fig. 2.
The infotainment buttons are operated by
pressing them or holding them down.

Switching on and off

To manually switch the Infotainment system
on and off, briefly press the rotary knob 
››› ›››
Fig. 1, Fig. 2 .
8
When the unit is switched on the system
starts up. The last active audio source will be
played with the volume set, as long this does
not exceed the maximum, predefined switch-
›››
on volume page 41.
The unit will switch off automatically when
the key is removed from the ignition or when
the on/off button is pressed (depending on
the equipment fitted or the vehicle). If you
turn the unit back on after the engine has
been switched off, it will turn off automatical-
1,
ly after approximately 30 minutes (delayed
switch-off).
1,
Note
● The unit is linked to the vehicle. It cannot
be used in any other vehicle.
● If only the battery has been disconnected
from the vehicle, the vehicle must be started
before turning the unit back on.
MEDIA

Adjusting the base volume

Function Use
Increase Turn the volume control  clockwise or
the vol- scroll the
ume. multifunction steering wheel
let Instruction
Lower the Turn the volume control  anticlockwise
volume. or scroll the thumbwheel downwards
on the multifunction steering wheel.
The volume modification is shown on the
screen with a bar.
It is possible to preset certain volume set-
tings and adjustments
thumbwheel upwards on the

›››
Book-
Manual.

»
›››
page 41.
7