The nylon cutting head is a dual string trimmer head
provided with a bump & feed mechanism.
To feed the nylon cord, bump the cutting head against the
ground while rotating at a low RPM. The nylon cord is
automatically cut to the proper length by the cutter on the
protector.
NOTE:
If the nylon cord does not feed out while bumping
•
the head, rewind/replace the nylon cord by
following
the
"Maintenance."
Do not bump the tool to the concrete or asphalt
•
surface. Bumping to this kind of objects may cause
the tool damage.
Battery remaining capacity indicator (only for
models with Battery BL3622A)
Battery BL3622A is equipped with the battery remaining
capacity indicator.
1
2
011715
Press the CHECK button to indicate the battery
remaining capacity. The indicator lamps will light up for
approximately three seconds.
Indicator lamps
Lighted
Off
Blinking
E
011713
When only the lowermost indicator lamp (next to
•
the "E") blinks, or when none of the indicator lamps
light up, the battery capacity has run out, so the tool
does not operate. In these cases, charge the
battery or replace the empty battery with a fully
charged one.
procedures
described
1. Indicator lamps
2. CHECK button
Remaining capacity
70% to 100%
F
45% to 70%
20% to 45%
0% to 20%
Charge the battery.
The battery may have
malfunctioned.
When two or more indicator lamps do not light even
•
after charging is complete, which means that the
battery has reached the end of its service life.
When the upper two and lower two indicator lamps
•
light alternately, the battery may be malfunctioning.
Contact your local Makita authorized service
center.
NOTE:
The indicated capacity may be lower than the
•
under
actual level during use or immediately after using
the tool.
Depending on the conditions of use and the
•
ambient temperature, the indication may differ
slightly from the actual capacity.
ASSEMBLY
WARNING:
Always be sure that the tool is switched off and
•
battery cartridge is removed before carrying
out any work on the tool. Failure to switch off and
remove the battery cartridge may result in serious
personal injury from accidental start-up.
Never start the tool unless it is completely
•
assembled. Operation of the tool in a partially
assembled state may result in serious personal
injury from accidental start-up.
Installing the handle
1
012864
Fit the grip onto the shaft pipe and tighten them with two
screws. Make sure that the spacer on the shaft pipe is
located between the grip assembly and the other grip. Do
not remove or shrink the spacer.
NOTE:
In some countries, the spacer is not provided with
•
the tool. In that case, align the handle to further side
of the line which is indicated by the arrow marks.
9
1. Grip
2. Spacer
2