Table of Contents
Advertisement
Speed change
1
012862
Two speed ranges can be preselected with the speed
change switch.
Flipping the speed change switch lever to the "1" position
will set the tool to the low speed range and the "2"
position will set the tool to the high speed range.
Battery/motor protection system
The battery cartridge and tool are provided with
protection functions that will automatically reduce or cut
-
Blinking
-
Lighting On
Blinking
Lighting On
Blinking
Blinking
010823
Nylon cutting head
NOTICE:
Do not attempt to bump feed the head while the tool
•
is operating at a high RPM. Bump feeding at a high
RPM may cause damage to the nylon cutting head.
The bump feed will not operate properly if the head
•
is not rotating.
1. Speed change
switch lever
Status
Battery power has been
nearly used up.
Battery protector is
shutting off the power -
battery power has been
used up.
Overload protector is shutting
-
off the power - the motor was
locked.
Overheat protector is shutting
-
off the power - overheating.
Electric or electronic
malfunction
off power when overload situations occur that may cause
damage to the tool or battery cartridge.
If the tool becomes overloaded but not locked up, a
protector is provided to reduce the revolutions to protect
the motor. In this case the two indicator lamps described
in the table below do not light or blink.
All other protection functions can be identified by the
indicator lights described in the table below.
1
012967
Action to be taken
Replace the battery with fully charged one.
Replace the battery with fully charged one.
Release the switch trigger and remove the
cause of the motor lock or overload. If the
cutting tool is locked by entangling weeds or
the like, always remove the battery cartridge
before clearing it.
Rest the equipment for a while.
Ask your local authorized service center for
repairs.
1
012863
8
1. Indicator lamps
1. Most effective
cutting area
Advertisement
Table of Contents
