Table of Contents
Advertisement
Cutting the grass near a tree, concrete block,
brick or garden stone
012890
Tilt the tool with paying attention that the tool does not
contact the ground surface. Approach the tip of the nylon
cord to the grass. Smooth feeding out may be needed
because the tip of the nylon cord touches the ground and
wears more quickly than usual.
NOTE:
Getting the trimmer too close to a tree, concrete
•
block, brick, garden stone or the like during the
edging work or similar cutting work may cause the
nylon cord to be cut off halfway inside the cutter
head. In that case, turn off the tool, remove the
cutting head and set the nylon cord properly again.
Regarding to how to set the nylon code, refer to the
section in "Maintenance".
It is recommended to keep the tool more than 5 cm away
from the tree, concrete block, brick, garden stone or the
like so that the tip of the nylon code does not contact the
hard obstacle and you can expect the best performance.
Start the trimmer before getting close to the grass to be
cut.
Cut the grass using the nylon cord tip by moving the
trimmer from right to left and proceed slowly, keeping the
trimmer at the angle of about 30
ground surface.
When cutting high grass, cut in layers always beginning
from the top with each cut length short.
MAINTENANCE
WARNING:
Always be sure that the tool is switched off and
•
battery cartridge is removed before attempting
to perform inspection or maintenance on the
tool. Failure to switch off and remove the battery
cartridge may result in serious personal injury from
accidental start-up.
NOTICE:
Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may
result.
Replacing the nylon cord
012902
Press inward on the housing latches and lift upward to
remove the cover. Discard any of the remaining nylon
cord.
012904
Hook the middle of the new nylon cord to the notch
located at the center of the spool between the 2 channels
provided for the nylon cord. One side of the cord should
be about 80mm longer than the other side.
Wind both ends firmly around the spool in the direction
in relation to the
marked on the head for right hand direction indicated by
RH.
010774
Wind all but about 100 mm of the cords, leaving the ends
temporarily hooked through a notch on the side of the
spool.
11
WARNING:
Make sure that the cover of the nylon cutting
•
head is secured to the housing properly as
described below. Failure to properly secure the
cover may cause the nylon cutting head to fly apart
resulting in serious personal injury.
2
3
1
2
1
100mm
1
1. Cover
1
2. Latches
3. Press
3
1. Spool
80mm
2. For right hand
rotation
1. Notches
Advertisement
Table of Contents
