Servicing The Bedbar - Toro 04038 Operator's Manual

Rollers: Standard and Optional
Part Number
99-6241
88-6790
104-2642
71-1550
93-9045
52-3590
93-9039
95-0930
Clip Kit
Part Number
65–9000

Servicing the Bedbar

Removing the Bedbar
1. Turn the bedbar adjuster screw counterclockwise to
back the bedknife away from the reel (Figure 54).
Figure 54
1. Bedbar adjusting screw
2. Spring tension nut
2. Back out the spring tension nut until the washer is no
longer tensioned against the bedbar (Figure 54).
3. On each side of the machine loosen the jam nut
securing the bedbar bolt (Figure 55).
Description
Narrow Wiehle
Wide Wiehle
Full Roller
Wiehle Roller
Wiehle Roller
Swaged Roller
Narrow Wiehle
Full Roller
Description
Clip Kit
3. Bedbar
Mower Diameter/Material
Greensmaster 1010
Greensmaster 1010
Greensmaster 1010
Greensmaster 1010
Greensmaster 1010
Greensmaster 1010
Greensmaster 1610
Greensmaster 1610
Mower
Decrease clip to 0.25"
Greensmaster 1010 &
Greensmaster 1610
1. Jam nut
4. Remove each bedbar bolt allowing the bedbar to be
pulled downward and removed from the machine. Save
the 2 nylon and 2 stamped steel washers on each end
of the bedbar (Figure 55).
Installing the Bedbar
1. Install the bedbar, positioning the mounting ears
between the washer and the bedbar adjuster.
2. Secure the bedbar to each side plate with the bedbar
bolts (jam nuts on the bolts) and 8 washers. Position a
nylon washer on each side of the side plate boss. Place
a steel washer outside each of the nylon washers.
3. Torque the bolts to 27 to 36 N-m (240 to 320 inch-lb).
4. Tighten the jam nuts until the outside thrust washers
just rotate freely.
5. Tighten the spring tension nut until the spring is
collapsed, then back it off 1/2 turn.
6. Adjust the bedbar; refer to Adjusting the Bedknife to
the Reel (page 31).
35
Comments
2.0 inches Aluminum Standard, 0.2 Spacing
2.0 inches Aluminum More Penetration, 0.43
Spacing
2.0 inches Steel Least Penetration
2.0 inches Cast Iron More Penetration, 0.43
Spacing
2.5 inches Aluminum
24 inches Wide for Edge
Support
2.5 inches Aluminum
2.5 inches Aluminum Standard
Least Penetration
2.5 inches Steel
Comments
1
Figure 55
2. Bedbar bolt
2
g014780