Sharp LC-26D7U Operation Manual page 9
Hide thumbs
Also See for LC-26D7U:
- Operation manual (102 pages) ,
- Operation manual (101 pages) ,
- Service manual (214 pages)
Table of Contents
Advertisement
QUICK REFERENCE
TV GUIDE ON SCREENTM QUICK SETUP SHEET
Once you set up the TV according to this operation manual, you are ready to set up TV Guide On Screen!
Note: TV Guide On Screen™
interactive program guide supports cable-ready, cable box and digital cable
services as well as over-the-air broadcast. It does not provide listings for satellite services.
E(S~RC~RN
-
FAVORITE
CH -
0---®----®=@
-
DAY
+
RECORD
~
MENU
II
<5~61
I~--"/T/""'/~
ENTER
Use the TV remote for On-Screen Setup
CD
Press
.,/T
I .....
/~
and ENTER to highlight an
item in a Setup screen.
®
Press ENTER to select that item.
Place the G-LINK cable(s)
To control a VCR, place one of the G-LINK
cables underneath the VCR approximately 1
inch in front of the sensor you found in step 2.
If you have a cable box, place the other G-
LINK cable approximately 1 inch in front of
the sensor you found in step 2.
Use the double-sided tape to secure each
G-LINK cable.
Correct
Incorrect
Find the VCR and Cable Box IR Sensors.
To control recording, find the VCR's IR sensor.
CD
Turn the VCR off.
®
Hold the VCR remote so that it touches the
front of the VCR (Figure 1).
@
Move the remote across the front while
pressing POWER (Figure 2). (You must press
and release the power button each time you
move the remote; holding down the button will
not work).
@
When the VCR powers on, you have found
the sensor.
@
Remember the location of the sensor, and go
to step 3.
If you have a cable box, repeat this procedure
using the cable box and its remote, and then
go to step 3.
Figure 1
Figure 2
~
00t6'~".
~
~
~~;~~~//
. . ' . .
~"i~~
it'
.
:/
,::~~,->~:>'r ~iP
I
Find and Connect the included G-LINK cable
into the G-LINK terminal.
G-LINK cable with
Double-Sided Tape
Follow the on-screen instructions
If you previously skipped TV Guide On Screen setup,
you see the Reminder Screen.
Note: If you press ENTER and the screen does not
change, make sure that the batteries in the remote are
properly installed.
If you need to control a cable box and/or a VCR,
complete steps 1 through 3. If not, go to step 4.
After completing the TV's initial setup, you see the TV
Guide On Screen Setup Welcome Screen.
Note: If TV Guide On Screen is not setup, pressing TV
GUIDE while watching TV will display the Welcome
Screen.
@-8
Advertisement
Table of Contents
