Shutting Off The Machine; Adjusting The Height Of Cut - Toro 74997 Operator's Manual

Shutting Off the Machine

To shut off the machine, move the motion-control levers to
neutral and then to the N
the blade-control switch (PTO), and turn the ignition key to
the O position.
FF
Set the parking brake when you leave the machine; refer to
Setting the Parking Brake (page
the ignition switch.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.

Adjusting the Height of Cut

Using the Transport Lock
The transport lock has 2 positions, and is used with the
deck-lift pedal. There is a L
position for the transport position of the mower deck
27).
- position, disengage
EUTRAL LOCK
20). Remove the key from
position and an U
OCK NLOCK
(Figure
1. Transport lock
2. L position—The
OCK
mower deck locks into the
transport position.
26
Figure 27
Transport-Lock Positions
3. U
NLOCK
mower deck does not lock
into the transport position.
position—The