Storage; Cleaning And Storage - Toro 74997 Operator's Manual

Storage

Cleaning and Storage

1. Disengage the blade-control switch (PTO), set the
parking brake, and turn the ignition key to Off.
Remove the key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine and hydraulic system. Clean dirt and chaff from
the outside of the engine-cylinder-head fins and blower
housing.
Important: You can wash the machine with mild
detergent and water. Do not pressure-wash the
machine. Avoid excessive use of water, especially
near the control panel, engine, hydraulic pumps,
and motors.
3. Check the brake.
4. Service the air cleaner; refer to
Cleaner (page 38).
5. Grease the machine; refer to
6. Change the crankcase oil; refer to
Oil (page 40).
7. Check the tire pressure; refer to
Pressure (page 48).
8. Change the hydraulic filters; refer to
Hydraulic Filters and Hydraulic Fluid (page
9. Charge the battery; refer to
46).
10. Scrape any heavy buildup of grass and dirt from the
underside of the mower, then wash the mower with
a garden hose.
Note: Run the machine with the blade-control switch
(PTO) engaged, and the engine at high idle for 2 to
5 minutes after washing.
11. Check the condition of the blades; refer to
the Cutting Blades (page
12. Prepare the machine for storage when non-use occurs
over 30 days. Prepare the machine for storage as
follows:
A. Add a petroleum-based stabilizer/conditioner to
fuel in the tank. Follow mixing instructions from
the stabilizer manufacturer. Do not use an alcohol
based stabilizer (ethanol or methanol).
Note: A fuel stabilizer/conditioner is most
effective when mixed with fresh fuel and used at
all times.
B. Run the engine to distribute conditioned fuel
through the fuel system (5 minutes).
C. Shut off the engine, allow it to cool, and drain the
fuel tank; refer to
44).
Servicing the Air
Lubrication (page 36).
Changing the Engine
Checking the Tire
Replacing the
59).
Charging the Battery (page
Servicing
63).
Servicing the Fuel Tank (page
D. Restart the engine and run it until it stops.
E. Dispose of fuel properly. Recycle as per local
codes.
Important: Do not store
stabilizer/conditioned fuel over 90 days.
13. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged.
14. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
15. Store the machine in a clean, dry garage or storage area.
16. Remove the key from the ignition switch and keep it
out of reach of children or other unauthorized users.
17. Cover the machine to protect it and keep it clean.
68