Toro 74997 Operator's Manual page 61

1
Figure 91
1. Deck-lift pedal
2. Height-of-cut pin
6. Insert the height-adjustment pin into the 7.6 cm (3
inch) height-of-cut location.
7. Release the transport lock and allow the deck to lower
to the cutting height.
8. Raise the discharge chute.
9. On both sides of the deck, measure from the level
surface to the front tip of the blade (Postion A) as
shown in Figure 92.
Note: The measurement should read 7.6 mm (3
inches)
3
G017027
3. Transport lock
2
1. 7.6 cm (3 inches) at
position A is correct.
2. 8.3 cm (3-1/4 inches) at
position B is correct.
10. If needed, loosen the flanged locknut on the side of the
yoke and the jam nut on top.
11. Fine-tune the adjuster screw by turning it to get 7.6
mm (3 inch) height
Note: To increase the height, turn the adjuster
screw clockwise; to decrease the height, turn it
counterclockwise.
2
1
G012430
1. Flanged locknut
2. Adjuster screw
61
Figure 92
3. Measure here from the
blade tip to the hard
surface.
4. Measure at position A and
B on both sides.
(Figure 93).
3 4
2 1
Figure 93
3. Jam nut
4. Yoke