Genie GTH-1048 Service Manual page 103

Section 4 • Repair Procedures
TRANSMISSION
kinked or pinched.
6 Tag, disconnect and plug the hydraulic pump
high pressure line at the function manifold. Cap
the fitting.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
Component damage hazard.
Hoses can be damaged if they are
kinked or pinched.
7 Tag, disconnect and plug the hydraulic pump
supply line at the pump. Cap the orifice on the
pump.
8 Remove the fasteners securing the
transmission mounting flange to the chassis.
9 Tag and disconnect the driveshafts from the
transmission.
Note: To avoid damage to the driveshaft universal
joints, secure the driveshafts to the chassis.
10 Tag and disconnect the wiring harness from the
transmission.
11 Attach a lifting strap from an overhead crane to
the center point of the transmission.
12 Remove the fasteners securing the
transmission mounting flange to the chassis.
Remove the transmission from the machine.
Crushing hazard. The
transmission will fall if not properly
supported when removed from the
machine.
4 - 34 GTH-1048 • GTH-1056
March 2015
Part No. 123701