Table of Contents
Advertisement
HOSE SAFETY
Tighten all fluid connections securely before each use.
Do not use fluids or solvents which are not compat-
Never use a damaged hose. Before each use, check
the entire hose for cuts, leaks, abrasion, bulging
cover, or damage or movement of the hose couplings.
If any of these conditions exist, replace the hose
immediately.
ible with the system air hose(@.
FIRE
OR
EXPLOSIO HAZARD
Sparking and Flammable Vapors Hazard
Sparking can be expected in the normal operation of Avoid all
ignition sources such as static electricity
the turbine motor. Sparks could ignite fumes from from
plastic drop cloths, open flames such as pilot
flammable liquid, dust particles and other flammable
lights, hot objects such as cigarettes, arcs from con-
substances in the spray area, and cause serious
injury and property damage. Be sure to follow the pre-
switches on and
off.
Extinguish or remove all sources
necting or disconnecting power cords or turning
light
cautions below:
of ignition.
Ignition Sources
When flammable liquid is sprayed or used for
flushing or cleaning equipment, the turbine must
be placed at least 20 feet (6.1 m) away from areas
where hazardous concentrations of flammable
vapors are likely to occur.
Use additional air hose if necessary to ensure that
the turbine is operated in a clean, dry, well venti-
lated area.
Never place the turbine inside
a
spray booth! Use
this equipment outdoors or in extremely well venti-
lated areas.
Grounding
To reduce the risk of static sparking, ground the tur-
bine and all other spray equipment used or located in
the spray area. Check your local electrical code for
detailed grounding instructions for.your area and type
of equipment.
To ground the turbine: Plug the power supply cord
into a properly grounded outlet.
Do
not remove the
grounding prong from the power cord. Do not use an
adapter. Extension cords must have
three wires and
be rated for a minimum of 15 amps.
. ,
IMPORTANT
dards--particularly
the
General Standards, Part
1910
and
the
Construction Standards, Part 1926--should be consulted.
United
States Government safety standards have been adopted under
the
Occupational Safety and
Health
Act.
These
stan.
Table of Contents
Warnings..
....................................
2
................................
10
General Information
............................
4
...............................
11
................................
5
...................................
.:. .
12
...................................
5
Parts..
.......................................
15
Setup,.
.......................................
..................................
23
.....................................
9
.............................
Backcover
308-422
3
- Quick Links:
- Specifications
- Setup
- Parts
Hide quick links:
Advertisement
Table of Contents
