Specifications - Toro 04038 Operator's Manual

Reel Drive Lever
The reel drive lever (Figure
corner of the machine. The lever has 2 positions: Engage
and Disengage. Move the lever forward to engage the reel or
rearward to disengage the reel.
1
Figure 13
1. Reel drive lever
Choke Lever
The choke lever (Figure 14) is located on the left front of the
engine. The lever has 2 positions: Run and Choke. Move the
lever to the Choke position when starting a cold engine. After
the engine starts, move the lever to the Run position.
Figure 14
1. Choke lever
Fuel Shut-off Valve
The fuel shut-off valve (Figure
of the engine near the choke lever. The valve has 2 positions:
Closed and Open. Move the lever up to the closed position
when storing or transporting the machine. Open the valve
before starting the engine by rotating the lever down.
13) is located on the right front
G016978
G019637
1 2
2. Fuel shut-off valve
14) is located on the left front
Recoil Starter
Pull the recoil starter handle
1. Recoil starter
Kickstand
The kickstand (Figure
machine and is used to raise the rear of the machine for
installation or removal of the transport wheels.

Specifications

Model 04038
Width 91 cm (36 inches)
Height 99 cm (39 inches)
Length with basket 140 cm (55 inches)
Dry weight (with 100 kg (220 lb)
basket and Wiehle
roller; without
wheels or grooming
reel)
Width of cut 53 cm (21 inches)
1.6 mm to 31.8
Height of cut
mm (0.063 to 1.25
inches)
Clip 3.6 mm (0.14 inch)
Engine speed Low idle –1565
±150 rpm, High idle
– 3375 ±100 rpm
14
(Figure 15) to start the engine.
Figure 15
2. Kick stand
15) is mounted to the rear of the
Model 04039
104 cm (41 inches)
99 cm (39 inches)
142 cm (56 inches)
105 kg (232 lb)
66 cm (26 inches)
3.1 mm to 31.7
mm (0.125 to 1.25
inches)
3.6 mm (0.14 inch)
Low idle –1565
±150 rpm, High idle
– 3375 ±100 rpm