Adjusting The Cutting Unit; Installing The Grass Basket - Toro 04038 Operator's Manual

1. Locking clip
3. Rotate the wheel back and forth until it slides
completely onto the axle and the locking clip is secured
in the groove on the axle shaft.
4. Repeat the procedure on the opposite side of the
machine.
5. Inflate the tires to 574 to 718 Pa (12 to 15 psi.).
5

Adjusting the Cutting Unit

No Parts Required
Procedure
Before operating the machine, complete the following
adjustments:
•
Adjusting the Bedknife to the Reel (page
•
Adjusting the Height-of-Cut (page
•
Adjusting the Grass Shield Height (page
•
Adjusting the Cut-off Bar (page
G017591
Figure 8
32).
33).
34).
34).
6

Installing the Grass Basket

Parts needed for this procedure:
1 Grass basket
Procedure
Grasp the basket by the top lip and slide it onto the basket
mounting rods (Figure
1. Grass basket
Note: Model 04039 only—When cutting in higher
heights-of-cut, the basket may be lowered by removing each
basket mounting rod and installing each on the opposite side
of the machine.
12
9).
Figure 9
2. Basket mounting rod