1.10.1 Connection To Peripherals; Figure 1-17 Installation Into A Typical Vme Chassis - Emerson MVME55006E Installation And Use Manual

Hardware Preparation and Installation
4. Ensure that the levers of the two injector/ejectors are in the outward position.
5. Slide the MVME5500 into the chassis until resistance is felt.
Figure 1-17 Installation into a Typical VME Chassis
6. Simultaneously move the injector/ejector levers in an inward direction.
7. Verify that the MVME5500 is properly seated and secure it to the chassis using the
two screws located adjacent to the injector/ejector levers.
8. Connect the appropriate cables to the MVME5500.

1.10.1 Connection to Peripherals

When the MVME5500 is installed in a chassis, you are ready to connect peripherals and apply
power to the board.
Figure 1-1 on page 24
for you. Refer to
connectors listed below.
42
shows the locations of the various connectors while
Chapter 5, Connector Pin Assignments
MVME55006E Single Board Computer Installation and Use (6806800A37H)
Table 1-3
for the pin assignments of the
lists them