Table of Contents
Advertisement
Hardware Preparation and Installation
Procedure
This procedure assumes that you have read the user's manual that came with your PMCs.
1. Attach an ESD strap to your wrist. Attach the other end of the ESD strap to an
electrical ground. Note that the system chassis may not be grounded if it is
unplugged. The ESD strap must be secured to your wrist and to ground throughout
the procedure.
2. Perform an operating system shutdown. Turn the AC or DC power off and remove
the AC cord or DC power lines from the system. Remove chassis or system cover(s)
as necessary for access to the VME modules.
3. If the MVME5500 has already been installed in a VMEbus card slot, carefully remove
it as shown in
Remove the filler plate(s) from the front panel of the MVME5500.
4. Insert the appropriate number of Phillips screws (typically 4) from the bottom of
the MVME5500 into the standoffs on the PMC module and tighten the screws (refer
to
Figure
36
Figure 1-17
and place it with connectors P1 and P2 facing you.
1-15).
MVME55006E Single Board Computer Installation and Use (6806800A37H)
Advertisement
Table of Contents
