Flash Boot Bank Select Header (J8); Vme Scon Select Header (J27); Table 5-24 Flash Boot Bank Select Header (J8) Pin Assignments; Table 5-25 Vme Scon Select Header (J27) Pin Assignments - Emerson MVME55006E Installation And Use Manual

5.3.2

Flash Boot Bank Select Header (J8)

A 3-pin 2 mm planar header selects the boot Flash bank. No jumper or a jumper installed across
pins 1-2 selects Flash 0 as the boot bank. A jumper installed across pins 2-3 selects Flash 1 as
the boot bank. The pin assignments for this header are as follows:

Table 5-24 Flash Boot Bank Select Header (J8) Pin Assignments

Pin
1
2
3
5.3.3

VME SCON Select Header (J27)

A 3-pin 2 mm planar header allows the choice for auto/enable/disable SCON VME
configuration. A jumper installed across pins 1-2 configures for SCON disabled. A jumper
installed across pins 2-3 configures for auto SCON. No jumper installed configures for SCON
always enabled. The pin assignments for this header are as follows:

Table 5-25 VME SCON Select Header (J27) Pin Assignments

Pin
1
2
3
MVME55006E Single Board Computer Installation and Use (6806800A37H)
Signal
GND
BANK_SEL
+3.3V
Signal
No SCON
SCON
Auto-SCON
Connector Pin Assignments
115