For All Installations - Faber CYLINDRA ISOLA Installation Instructions Manual

FOR ALL INSTALLATIONS CONTINUED
4. When installing the hood ductless, the holes in the upper
stainless chimney need to be positioned up, in the ducted
version, the holes should be on the bottom.
5. Place the chimney on the frame and attach it to the upper
part of the frame with screws. Make sure to match the
ductless holes with the ductless box inside the frame if using
the ductless application. (FIGURE 9)
6. Remove the grease filters by pushing the handle backwards
and use 4 screws to attach the chimney to the frame on the
bottom, do not tighten screws (FIGURE 9)
7. Attach the chimney to the frame by inserting the screws
into the matching key holes and turn left and tighten screws.
(FIGURE 9)
8. Reinstall grease filters and install the comfort panel as in
FIGURE 12
9. Connect the control and lighting wires as shown in
FIGURE 10.
FIGURE 9
FIGURE 10

FOR ALL INSTALLATIONS

1. Remove the cover from the Field Wiring Compartment with
a phillips screwdriver. Feed the Power Supply Cable through
the electrical knockout. (See FIGURE 11) Connect the Power
Supply Cable to the rangehood cable. Attach the White lead
of the power supply to the White lead of the rangehood with a
twist-on type wire connector. Attach the Black lead of the power
supply to the Black lead of the rangehood with a twist-on type
wire connector. Attach the Power Supply Cable grounding lead
to the green screw provided. Using the 4 holes provided screw
the Field Wiring Compartment to the wall as dictated by your
Power Supply Cable location (screws not provided). Replace
the cover.
2. Turn the power supply on. Turn on blower and lights. If the
rangehood does not operate, check that the circuit breaker is
not tripped or the house fuse blown. If the unit still does not
operate, disconnect the power supply and check that the wiring
connections have been made properly.
FIGURE 11
USE AND CARE
The inside area of the perimetric comfort panel can be cleaned
using a damp cloth and is opened by gently pulling the panel
down on he front side. The panel can be removed from the hood
by sliding the fixing pin to the side as in (FIGURE 12).
FIGURE 12
Version 09/12- Page 7