Onkyo TX-SR603/603E Instruction Manual page 51

First Time Setup —Continued
Equalizer Setting
This setting is set automatically by the Automatic
Speaker Setup function (see page 39).
Here you can adjust the EQ of individual speakers. To set
the volume of individual speakers see page 50.
1
2
1 Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
RECEIVER
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "5. Equalizer
Settings," and then press
ENTER
[ENTER].
The Equalizer Settings menu appears.
ENTER
3
ENTER
4
ENTER
2–6
1, 7
ENTER
5
ENTER
]/[ ]
6
7
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
Use the Left and Right [ ]/[
buttons to select:
Off: Tone off, response flat.
Auto: The tone for each speaker is
set automatically by the
Automatic Speaker Setup
function.
Manual: You can adjust the EQ of each
speaker manually.
If you select Manual, continue with this
procedure. If you select Off or Auto, go
to step 7.
Use the Down [ ] button to
select "Channel," and then use
the Left and Right [ ]/[ ] but-
tons to select a speaker.
Use the Up and Down [ ]/[
buttons to select a frequency,
and then use the Left and Right
[ ]/[ ] buttons to adjust the
level at that frequency.
The volume at each frequency can be
adjusted from –6 to +6 dB in 1 dB
steps.
Tip: Low frequencies (e.g., 80 Hz)
affect bass sounds; high frequencies
(e.g., 8 kHz) affect treble sounds.
Use the Up [ ] button to select
"Channel," and then use the Left
and Right [ ]/[ ] buttons to
select another speaker.
Repeat steps 5 and 6 for each speaker.
Press the [SETUP] button.
The setup menu closes.
]
]
51