Adjusting The Rollers - Toro 31335 Operator's Manual

reverse the machines direction to pull any clippings
away from the wheel/fork area.
Front Castor Wheels
1. Remove the tensioning cap from the spindle shaft
(Figure 7) and slide the spindle out of the castor
arm. Put the 2 shims (1/8 inch) onto the spindle
shaft as they were originally installed. These shims
are required to achieve a level across the entire width
of the cutting units. Slide the appropriate number
of 1/2 inch spacers onto the spindle shaft to get the
desired height-of-cut; then slide the washer onto
the shaft.
Refer to Figure 8 to determine the combinations
of spacers for the setting.
2. Push the castor spindle through the castor arm.
Install the shims (as they were originally installed)
and the remaining spacers onto the spindle shaft.
Install the tensioning cap to secure the assembly.
Note: When using 1 inch (25 mm), 1-1/2 inch (38
mm), or occasionally 2 inch (51 mm) height–of–cut,
move the skids and roller to the highest holes.
Rear Castor Wheels
1. Remove the tensioning cap from the spindle shaft
(Figure 9).
G018263
1. Tensioning cap
2. Shims
3. "C" Shaped spacers
Figure 9
4. Castor Wheel
5. Axle mounting holes
Note: The rear castor fork assembly does not need
to be removed from the castor arm to change the
height-of-cut.
2. Remove or add "C" shaped spacers at the narrow
portion of the spindle shaft, below the castor arm,
to get the desired height-of-cut. Make sure that the
shims, not the spacers, contact the top and bottom
of the castor arm.
3. Install the tensioning cap to secure the assembly.
4. Ensure that all four castor wheels are set at the same
height-of-cut.
Note: When using 1 inch (25 mm), 1-1/2 inch (38
mm), or occasionally 2 inch (51 mm) height–of–cut,
move the skids and roller to the highest holes.

Adjusting the Rollers

Note: If the cutting unit is to be used in the 1 or 1-1/2
in. (25 or 38 mm) height-of-cut setting, the cutting unit
rollers must be repositioned in the top bracket holes.
To adjust the front rollers (Figure 10).
1. Remove the screw and nut securing the roller shaft
to the deck bracket.
1. Roller
2. Slide the shaft out of the lower bracket holes, align
the roller with the top holes, and install the shaft.
3. Install the screw and nut to secure the assemblies.
To adjust the rear (internal) rollers (Figure 11)
14
Figure 10
2. Roller shaft