Inspecting And Sharpening The Blade(S) - Toro 31335 Operator's Manual

72in guardian recycler mower 72in side-discharge mower traction unit
Hide thumbs Also See for 31335:
Table of Contents

Advertisement

Inspecting and Sharpening the
Blade(s)
Service Interval: Before each use or daily
Every 50 hours
DANGER
A worn or damaged blade can break, and a piece
of the blade could be thrown into the operator's
or bystander's area, resulting in serious personal
injury or death.
• Inspect the blade periodically for wear or
damage.
• Do not try to straighten a blade that is bent.
• Never weld a broken or cracked blade.
• Replace a worn or damaged blade with a
new Toro blade to ensure continued safety
certification of the product.
Two areas must be considered when checking and
servicing the cutting blade: the sail and the cutting edge.
Both cutting edges and the sail, which is the turned up
portion opposite the cutting edge, contribute to a good
quality-of-cut. The sail is important because it pulls grass
up straight, thereby producing an even cut. However,
the sail will gradually wear down during operation, and
this condition is normal. As the sail wears down, the
quality-of-cut will degrade somewhat, although the
cutting edges are sharp. The cutting edge of the blade
must be sharp so that the grass is cut rather than torn.
A dull cutting edge is evident when the tips of the grass
appear brown and shredded. Sharpen the cutting edges
to correct this condition.
1. Position the machine on a level surface. Raise the
cutting unit, engage the parking brake, put the
traction pedal in neutral, put the PTO lever in
the Off position, stop the engine, and remove the
ignition key.
2. Examine the cutting ends of the blade carefully,
especially where the flat and curved parts of the
blade meet (Figure 31). Since sand and abrasive
material can wear away the metal that connects
the flat and curved parts of the blade, check the
blade before using the machine. If wear is noticed
(Figure 31), replace the blade; refer to Removing the
Cutting Blade.
1. Cutting edge
2. Curved area/sail
WARNING
If the blade is allowed to wear, a slot will form
between the sail and flat part of the blade
(Figure 31). Eventually, a piece of the blade may
break off and be thrown from under the housing,
possibly resulting in serious injury to yourself
or bystanders.
• Inspect the blade periodically for wear or
damage.
• Replace a worn or damaged blade with a
new Toro blade to ensure continued safety
certification of the product.
3. Examine the cutting edges of all blades. Sharpen the
cutting edges if they are dull or nicked. Sharpen only
the top side of the cutting edge and maintain the
original cutting angle to ensure sharpness (Figure 32).
The blade will remain balanced if the same amount
of metal is removed from both cutting edges.
1. Sharpen at original angle
Note: Remove the blades and sharpen them on a
grinder; refer to Removing the Cutting Blades. After
sharpening the cutting edges, install the blade with
the anti-scalp cup and blade bolt. The blade sails
must be on top of the blade. Tighten the blade bolt
to 85-110 ft-lb (115-149 N-m).
24
Figure 31
3. Wear/slot forming
4. Crack
Figure 32

Advertisement

Table of Contents
loading

This manual is also suitable for:

31336Groundsmaster 3280-d

Table of Contents