Table of Contents
Advertisement
1
3
Figure 14
1. Unlock lever
2. Rotate the cam lock to
increase or decrease
locking pressure
Positioning the Flow Baffle
(Model 31336 only)
The following figures are only recommendations for
use. Adjustments will vary by grass type, moisture
content, and height of grass.
Note: If the engine power draws down and the mower
ground speed is the same, open up the baffle.
Position A
This is the full rear position. The suggested use for this
position is a follows.
• Use for short, light grass mowing conditions.
• Use in dry conditions.
• For smaller grass clippings.
• Propels grass clippings farther away from the
mower.
Figure 15
2
4
G008961
3. Position the baffle
4. Lock lever
Position B
Use this position when bagging. Always align it with
the blower opening.
Position C
This is the full open position. The suggested use for
this position is as follows.
• Use in tall, dense grass mowing conditions.
• Use in wet conditions.
• Lowers the engine power consumption.
• Allows increased ground speed in heavy conditions.
Adjusting the Cutting Unit
Pitch
Cutting unit pitch is the difference in height-of-cut
from the front of the blade plane to the back of the
blade plane. Toro recommends a blade pitch of 5/16
in. (8 mm). That is the back of the blade plane is 5/16
in. (8 mm) higher than the front.
1. Position the machine on a level surface on the shop
floor.
2. Set the cutting unit to the desired height-of-cut.
3. Rotate 1 blade so that it points straight forward.
16
Figure 16
Figure 17
Advertisement
Table of Contents
