Table of Contents
Advertisement
Figure 11
1. Internal rollers
Adjusting the Skids
The skids should be mounted in the lower position
when operating in height of cuts greater than 2-1/2
inches (64 mm) and in the higher position when
operating in height of cuts lower than 2-1/2 inches (64
mm).
Adjust the skids by removing the flange bolt and nuts,
positioning them as desired, and installing the fasteners
(Figure 12).
Figure 12
1. Skid
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is
recommended to adjust the height of the anti-scalp
rollers.
1. After adjusting the height-of-cut, adjust the rollers
by removing the flange nut, bushing, spacer, and
bolt (Figure 13).
1. Anti-scalp roller
2. Spacer
3. Bushing
2. Select a hole so the anti-scalp roller is positioned to
the nearest corresponding height-of-cut desired.
3. Install the flange nut, bushing, spacer, and bolt.
Torque to 40-45 ft-lb (54-61 N-m) (Figure 13).
Adjusting the Flow Baffle
(Model 31336 only)
The mower discharge flow can be adjusted for different
types of mowing conditions. Position the cam locks and
baffle to give the best quality of cut.
1. To adjust the cam locks, swing the lever up to
loosen the cam lock (Figure 14).
2. Adjust the baffle and cam locks in the slots to the
desired discharge flow.
3. Swing the lever back over to tighten the baffle and
cam locks (Figure 14).
4. If the cam locks do not lock the baffle into place
or it is too tight, loosen the lever and then rotate
the cam lock. Adjust the cam lock until the desired
locking pressure is achieved.
15
Figure 13
4. Flange Nut
5. Bolt
Advertisement
Table of Contents
