Displaying Radio Text (Rt); Performing A Pty Scan; Performing A Tp Scan - Onkyo TX-NR900E Instruction Manual

Listening to RDS broadcasts

Displaying Radio Text (RT)

If the station you are currently tuned into is broadcasting RT signals,
they will be displayed in the front display on the TX-NR900E. If the
station does not, this function will be ignored.
1. To display the radio text, press the
RT/PTY/TP button once.
• If the current station you are listening to is not an RDS station,
only the frequency of the station will appear.
• If "Waiting" appears on the display, more time is required to
receive the RT information. When the information is received,
the characters will scroll across the front display.
• If "No Text Data" appears on the display, RT information is not
available.
• The display shows the frequency for 3 seconds and returns to
program service name.

Performing a PTY scan

1. Press the TUNER input source button
and select the FM input source.
2. Press the RT/PTY/TP button twice.
The current program type appears on the
display.
3. Using the PRESET
select the PTY program type you
desire.
STANDBY/ON
STANDBY
POWER
ON OFF
ZONE 2 ( GRN )
REC ( RED )
DVD VIDEO 1 VIDEO 2
AUDIO
SELECTOR
PURE AUDIO UPSAMPLING
VCR 1 VCR 2
PHONES
REC OUT ZONE 2 OFF STEREO SURROUND THX
ZONE 2 LEVEL
RT/PTY/TP
RT/PTY/TP
TUNER
RT/PTY/TP
/ buttons,
PRESET
TUNER
MASTER VOLUME
VIDEO 3 VIDEO 4 VIDEO 5 TAPE TUNER PHONO C D NET AUDIO
DISPL AY
VIDEO 5 INPUT
DSP RT/ PTY/ TP MEMORY FM MODE SETUP ENTER RETURN
CLEAR TUNING PRESET
DIGITAL S VIDEO VIDEO L AUDIO R
PRESET
/
ENTER
4. Press the ENTER button.
The TX-NR900E will scan until it reaches a
station of the program type you selected. It
will then stop briefly at that station before
continuing on until it reaches the next
station. Pressing the ENTER button stops
the PTY scan at that point. If you press the
RT/PTY/TP while "NONE" is displayed,
"PTY ?" will appear. In this case, return to
step 3.
5. Press the ENTER button when it
reaches the station that you want to
listen to.
"Not Found" will appear when no RDS
signal is being received from the station.

Performing a TP scan

1. Press the TUNER input source button.
2. Press the RT/PTY/TP button three
times.
"[TP]" will appear if the current station is broadcasting TP
signals. This station will periodically broadcast traffic
information. To find a different station, proceed to the next step.
Also, if "TP" is displayed, proceed to the next step.
3. Press the ENTER button.
The TX-NR900E will scan until it reaches a
station broadcasting traffic information. If
"Not Found" appears on the display, a TP
station cannot be located.
ENTER
ENTER
TUNER
RT/PTY/TP
ENTER
39