Switching The Display; Adjusting The Brightness Of The Front Display; Temporarily Changing The Speaker Output Levels - Onkyo TX-NR900E Instruction Manual

Enjoying music or videos with the TX-NR900/900E
STANDBY/ON
STANDBY
PURE AUDIO UPSAMPLING
PHONES
ZONE 2 LEVEL

Switching the display

While listening to or watching an input source, you can display the
information regarding the type of source and signal being input by
pressing the DISPLAY button on the TX-NR900/900E or the remote
controller.
TX-NR900/900E
DISPL AY
When an input source other than FM or AM is selected:
Input
Program format*
Input +
Listening mode
or Multi Ch
* When the input signal is digital audio
The program format is displayed. For example, the display
"Dolby D: 3/2.1" shows that the format is Dolby Digital with 5.1
discrete channels consisting of three front channels (front left,
front right, and center), two surround channels (surround left and
surround right), and the low frequency effect (LFE) channel.
When the front channel number is 2, they are the front left and
front right; when it is 1, it is monaural. When the surround
channel number is 1, it is monaural; when it is 0, there is no
surround channel. When no LFE number is given, there is no
LFE channel. Also, if there is no program format for the input
signal, nothing will be displayed.
When the input signal is linear PCM
The sampling frequency is displayed. For example, the display
"PCM fs: 44.1k" shows that the signal is PCM and that the
sampling frequency is 44.1 kHz.
When FM or AM is selected as the input source:
FM/AM frequency +
Preset no.
FM/AM +
Listening mode
34
ZONE 2 ( GRN )
REC ( RED )
AUDIO DVD VIDEO 1 VIDEO 2 VIDEO 3 VIDEO 4 VIDEO 5 TAPE TUNER PHONO C D
SELECTOR
VCR 1 VCR 2
REC OUT ZONE 2 OFF STEREO SURROUND THX DSP DIMMER MEMORY FM MODE SETUP ENTER RETURN
CLEAR TUNING PRESET
DIMMER
Remote controller
MASTER VOLUME
NET AUDIO
DISPL AY
DISPLAY
VIDEO 5 INPUT
DIGITAL S VIDEO VIDEO L AUDIO R
DISPLAY

Adjusting the brightness of the front display

You can adjust the brightness of the front display of the TX-NR900/
900E using the DIMMER button on the remote controller or on the
TX-NR900/900E front panel (other than European models).
TX-NR900/900E
DIMMER

Temporarily changing the speaker output levels

To change the individual speaker volumes temporarily, follow the
procedure given below. Each channel can be set between –12 and
+12 decibels (between –15 and +12 decibels for the subwoofer).
Note that the speaker volumes will return to the original settings
when the TX-NR900/900E is put in the standby state.
1. Press the RCVR MODE button.
2. Press the CH SEL button and select
the desired speaker.
3. Press the LEVEL
adjust the volume level.
Notes:
• You cannot select a speaker if it is set to "No" or "None" in the
Speaker Config Sub-menu of the Speaker Setup Menu.
• To have your new speaker levels set here overwrite the settings
at Setup Menu → Speaker Setup Menu → Level Calibration
Sub-menu, press the TEST button after you complete step 3 in
the procedure above.
ch
RCVR
CH SEL
Remote controller
or button to
TEST
LEVEL /
DIMMER