PlasmaMade GUC 1314 Airfilter Installation And User Manual page 28

Wall mounting
1. Using a spirit level, draw a straight line op the spot where you would like to
fix the bracket. Drill the first hole (also take into account the maximum size
specified in the blueprint). Drill a second hole 90 mm above or next to the
initial hole (use the mounting bracket if necessary to determine the location
of the second hole).
2. Fold both sides of the mounting bracket and secure it to the wall by means
of the supplied screws (4.2x25 mm) and screw anchors.
3. Slide the PlasmaMade® Airfilter onto the mounting bracket.
4. Install ductwork between the engine case and the PlasmaMade® Airfilter.
27