Table of Contents
Advertisement
Controls System
Maintenance
Adjusting the Control Lever
Neutral Interlock Switch
1. Stop the machine, move the control levers fully into
the neutral-locked position, set the parking brake, and
remove the ignition key.
2. Remove the bolts securing the front panel and remove
the panel (Figure 58).
Figure 58
1. Front panel bolts
3. Loosen the 2 screws securing the interlock switch
(Figure 59).
Figure 59
1. Control lever
2. Neutral interlock switch
4. Holding the control lever against the frame, move the
switch toward the lever until the distance between lever
3. Screws
4. 0.4 to 1 mm (0.015 to
0.045 inch)
and switch body is 0.4 to 1 mm (0.015 to 0.045 inch)
(Figure 59).
5. Secure the switch.
6. Repeat steps 3 to 5 for the other lever.
7. Install the front panel.
Adjusting the Control Lever
Neutral Return
If the motion control levers do not align with the neutral slots
when released from the reverse drive position, adjustment is
required. Adjust each lever, spring, and rod separately.
1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Move the throttle lever to the Slow position, stop the
engine, remove the key, and wait for all moving parts to
stop before leaving the operating position.
3. Remove the bolts securing the front panel and remove
the panel (Figure 60).
1. Front panel bolts
4. Move one of the levers to the neutral position but not
locked (Figure 62).
5. Pull the lever back until the clevis pin (on an arm
above the pivot shaft) contacts the end of the slot (just
beginning to put pressure on the spring) (Figure 61).
48
Figure 60
Advertisement
Table of Contents
