Table of Contents
Advertisement
1. Seat suspension knob
Changing the Back Position
The back of the seat can be adjusted to provide a comfortable
ride. Position the back of the seat where it is most
comfortable.
To adjust it, turn the knob, under the right-side arm rest, in
either direction to provide the best comfort (Figure 33).
Changing the Lumbar Support
The back of the seat can be adjusted to provide a customized
lumbar support for your lower back.
To adjust it, turn the knob, under the left-side arm rest, in
either direction to provide the best comfort (Figure 33).
Unlatching the Seat
To access the hydraulic and other systems under the seat, you
need to unlatch the seat and swing it forward.
1. Use the seat position adjustment lever to slide the seat
all the way forward.
2. Push one of the seat latches, located behind and to the
sides of the seat, rearward to unlatch the seat and pull
forward on the top of the seat (Figure 35).
Figure 34
2. Operator weight setting
1. Seat latch
Pushing the Machine by Hand
If the machine breaks, runs out of fuel, etc. you may need to
push it. To do so, you first need to open the hydraulic by-pass
valves.
Important: Always push the machine by hand. Never
tow the machine because hydraulic damage may occur.
Pushing the Machine
1. Disengage the power take off (PTO) and turn the
ignition key to off. Move the levers to the neutral
locked position and apply the parking brake. Remove
the key.
2. Lift the seat.
3. Rotate each by-pass valve counterclockwise 1 turn
(Figure 36).
This allows hydraulic fluid to by-pass the pump
enabling the wheels to turn .
Important: Do not rotate the by-pass valves more
than 1 turn. This prevents valves from coming out
of the body and causing fluid to run out.
29
Figure 35
Advertisement
Table of Contents
