Setup; Checking The Fluids And Tyre Pressure; Reading The Manual And Viewing The Operator Training Material - Toro 30069 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
Note: Determine the left and right sides of the machine from the normal operating position.
1
Checking the Fluids and Tyre
Pressure
No Parts Required
Procedure
• Before you start the engine and use the machine,
check the oil level in the engine crankcase; refer to
Checking the Engine Oil Level.
• Check the grease for the mower and mower deck.
• Check the tyre pressure; refer to Checking the tyre
Pressure.
Note: The cutting blades are set to a 2 inch (51mm)
height-of-cut at initial purchase. The Axle position is
B, with 2 spaces below the casters and 4 spaces below
the spindle.
Description
No parts required
Operator's Manual
Engine Operator's Manual
Parts Catalog
Operator training material
Registration Card
Oil drain hose
Qty.
–
Check the fluids and tyre pressure.
1
1
Read the Operator's Manual and watch
1
the operator training material before
1
operating the machine.
1
1
2
Reading the Manual and
Viewing the Operator Training
Material
Parts needed for this procedure:
1
Operator's Manual
1 Engine Operator's Manual
1 Parts Catalog
1 Operator training material
1
Registration Card
1 Oil drain hose
Procedure
• Read the Operator's Manual.
• View the operator training material before operating
the machine. The DVD supplied is general training
material and the machine may differ from that
supplied.
• Fill out the registration card.
• Use the oil drain hose when changing the engine oil.
10
Use