Product Overview; Specifications; Attachments/Accessories; Operation - Toro 30366 Operator's Manual

Product Overview

Specifications

Note: Specifications and design are subject to change
without notice.
Width of 60 inches (1.52 m) or 72 inches (1.829 m)
Cut
Height Adjustable from 1 to 5 inches (25 to 127 mm) in 1/2
of Cut inch (13 mm) increments
Net Model 30368–600 lb. (272 kg)
Weight Model 30366–450 lb. (204 kg)

Attachments/Accessories

A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.

Operation

Note: Determine the left and right sides of the
machine from the normal operating position.
CAUTION
If you leave the key in the ignition switch, someone
could accidently start the engine and seriously
injure you or other bystanders.
Remove the key from the ignition before you do
any maintenance.
Checking the Lubricant in the
Gear Box
Service Interval: Every 50 hours
The gear box in designed to operate on SAE 80–90
wt. gear lube. Although the gear box is shipped with
lubricant from the factory, check the level before
operating the cutting unit. The gear box capacity is 12
oz. (283 ml).
1. Position the machine and cutting unit on a level
surface.
2. Remove the dipstick/fill plug from the top of
the gear box (Figure 6) and make sure that the
lubricant is between the marks on the dipstick. If
the lubricant level is low, add enough lubricant until
the level is between the marks.
1. Dipstick/fill plug
12
Figure 6