Figure 10
7. Secure the adjustment with the clevis pin and hair
pin.
Note: Position the head of the clevis pin toward
the front of the deck, if possible.
Note: When using 1 inch (25 mm), 1-1/2 inch (38
mm), or occasionally 2 inch (51 mm) height–of–cut,
move the skids and roller to the highest holes.
Adjusting the Rollers
Note: If the cutting unit is to be used in the 1 or 1-1/2
in. (25 or 38 mm) height-of-cut setting, the cutting unit
rollers must be repositioned in the top bracket holes.
To adjust the front rollers (Figure 11).
1. Remove the screw and nut securing the roller shaft
to the deck bracket.
Figure 11
1. Roller
2. Roller shaft
2. Slide the shaft out of the lower bracket holes, align
the roller with the top holes, and install the shaft.
3. Install the screw and nut to secure the assemblies.
To adjust the rear (internal) rollers (Figure 12)
1. Internal rollers
Adjusting the Skids
The skids should be mounted in the lower position
when operating in height of cuts greater than 2-1/2
inches (64 mm) and in the higher position when
operating in height of cuts lower than 2-1/2 inches (64
mm).
Adjust the skids by removing the flange bolt and nuts,
positioning them as desired, and installing the fasteners
(Figure 13).
1. Skid
14
Figure 12
Figure 13