14.
Reinstall the seal guards over the wheel hub and insert
wheel into caster fork. Reinstall caster bolt and tighten
nut fully.
Important: To prevent seal and bearing damage, check
the bearing adjustment often. Spin the caster tire. The
tire should not spin freely (more than 1 or 2 revolutions)
or have any side play. If the wheel spins freely, adjust
torque on spacer nut until there is a slight amount of
drag. Reapply thread locking adhesive.
Engine Maintenance
Servicing the Air Cleaner
Note: Check the filters more frequently if operating
conditions are extremely dusty or sandy.
Removing the Air Filter
Service Interval: Every 250 hours (more often in dirty or
dusty conditions).
1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Release the latches on the air cleaner and pull the air
cleaner cover off of the air cleaner body (Figure 36).
4. Clean the inside of the air cleaner cover with
compressed air.
5. Gently slide the filter out of the air cleaner body
(Figure 36). Avoid knocking the filter into the side of
the body.
6. Inspect the filter for damage by looking into the filter
while shining a bright light on the outside of the filter.
Holes in the filter will appear as bright spots. If the
filter is damaged discard it.
1. Air filter body
2. Air filter
32
Figure 36
3. Air cleaner cover
4. Latches