Important: Lower the roll bar only when absolutely
necessary.
1. Remove the hairpin cotter pins and remove the two
pins (Figure 9).
2. Lower the the roll bar to the down position. There are
two down positions. See Figure 8 for the positions.
3. Install the two pins and secure them with the hairpin
cotter pins (Figure 9).
1. Full down position
Important: Ensure that the rear part of the seat is
secured with the seat latch.
4. To raise the roll bar, remove the hairpin cotter pins and
remove the two pins (Figure 9).
5. Raise the roll bar to the upright position and install
the two pins and secure them with the hairpin cotter
pins (Figure 9).
Important: Always use the seat belt with the roll
bar in the raised position.
Figure 8
2. Down position with bagger
installed
1
3
4
1. Roll bar
2. Raised position
Think Safety First
Please read all safety instructions and symbols in the safety
section. Knowing this information could help you or
bystanders avoid injury.
DANGER
Operating on wet grass or steep slopes can cause
sliding and loss of control.
Wheels dropping over edges can cause rollovers,
which may result in serious injury, death or
drowning.
There is no rollover protection when the roll bar is
down.
Always keep the roll bar in the raised and locked
position and use the seat belt.
Read and follow the rollover protection instructions
and warnings.
To avoid loss of control and possibility of rollover:
• Do not operate near drop-offs or near water.
• Do not operate on slopes greater than 15 degrees.
• Reduce speed and use extreme caution on
slopes.
• Avoid sudden turns or rapid speed changes.
18
2
G004955
Figure 9
3. Pin
4. Hairpin cotter pin