Unlatching the Seat
1. Move the seat to the most rearward position. This will
prevent interference when the seat is raised.
2. Push the seat latch rearward to unlatch the seat.
3. Raise the seat up. This will allow access to the machine
under the seat (Figure 28).
1. Seat latch
2. Fuel cap
Changing the Seat Suspension
The seat is adjustable to provide a smooth and comfortable
ride. Position the seat where you are most comfortable.
To adjust it the seat, turn the knob in front either direction
to provide the best comfort (Figure 29).
1
1. Seat suspension knob
Figure 28
3. Seat
g019768
Figure 29
Pushing the Machine by Hand
Important: Always push the machine by hand. Never
tow the machine because hydraulic damage may occur.
Pushing the Machine
1. Disengage the power take off (PTO) and turn the
ignition key to off. Move the levers to neutral locked
position and apply parking brake. Remove the key.
2. Rotate the by-pass valves counterclockwise 1 turn to
push. This allows hydraulic fluid to by-pass the pump
enabling the wheels to turn (Figure 30).
Important: Do not rotate by-pass valves more
than 1 turn. This prevents valves from coming out
of the body and causing fluid to run out.
3. Disengage parking brake before pushing.
Changing to Machine Operation
Rotate the by-pass valves clockwise 1 turn to operate machine
(Figure 30).
Note: Do not over tighten the by-pass valves.
The machine will not drive unless by-pass valves are turned in.
1. Side console controls
2. By-pass valve
26
Figure 30
3. Hydraulic pumps