Adjusting The Anti-Scalp Rollers; Positioning The Seat - Toro 74142TE Operator's Manual

Adjusting the Height-of-Cut Pin
Mower deck size Height-of-cut
range
122cm (48 inch) 38 to 127 mm
(1-1/2 to 5 inches)
The height-of-cut is adjusted by relocating the clevis pin into
different hole locations.
1. Move the transport lock to the lock position.
2. Push on the deck lift pedal with your foot and raise the
mower deck to the transport position (also the 5-1/2
inch (140 mm) cutting height position)
3. To adjust, rotate the pin 90 degrees and remove the pin
from the height-of-cut bracket
4. Select a hole in the height-of-cut bracket corresponding
to the height-of-cut desired and, insert the pin
24).
5. Push on the deck lift, pull back on the transport lock,
and slowly lower the mower deck.
3
1
Figure 24
1. Deck lift pedal
2. Cut of height pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is recommended
to adjust the height of the anti-scalp rollers.
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the neutral-locked position
and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
Increments
6 mm (1/4 inch)
(Figure 24).
(Figure 24).
(Figure
g017419
3. Transport lock
1. Anti-scalp roller
2. Spacer
3. Bushing
1. Anti-scalp roller
2. Bushing
2

Positioning the Seat

The seat can move forward and backward. Position the seat
where you have the best control of the machine and are most
comfortable.
To adjust, move the lever sideways to unlock seat
G008962
23
g017628
Figure 25
4. Flange nut
5. Bolt
Figure 26
3. Flange nut
4. Bolt
(Figure
Figure 27
g017629
27).