Controls System Maintenance; Adjusting The Control Handle Position - Toro 74142TE Operator's Manual

7. Remove the existing belt from the hydraulic unit drive
pulleys and the engine pulley
8. Install the new belt around the engine pulley and the
two drive pulleys.
2
1
6
Figure 64
1. Idler pulley
2. Idler spring post
3. Engine pulley
9. Install the clutch stop shown in
10. Install the mower belt. Refer to
Belt (page 43).
3
4
5
g017437
4. Pump drive belt
5. Right hand hydraulic pump
pulley
6. Left hand hydraulic pump
pulley
Figure 63.
Replacing the Mower
Controls System
Maintenance
Adjusting the Control Handle
Position
There are two height positions for the control levers; high and
low. Remove the bolts to adjust the height for the operator.
1. Disengage the PTO, move the motion-control levers to
the neutral-locked position, and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Loosen the bolts and flange nuts installed in the levers
(Figure 65).
4. Align the levers front to rear position by bring the
levers together to the neutral position and slide them
until they are aligned, then tighten the bolts
1. Bolt
2. Handle
45
(Figure
Figure 65
3. Control lever
4. Nut
66).