Servicing the Spark Plug
Service Interval: Every 100 hours
Make sure the air gap between the center and side electrodes
is correct before installing the spark plug. Use a spark plug
wrench for removing and installing the spark plug(s) and a
gapping tool/feeler gauge to check and adjust the air gap.
Install a new spark plug(s) if necessary.
Type of Spark Plug: NGK
Air Gap: 0.75 mm (0.030 inch)
Removing the Spark Plug
1. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
2. Disengage the PTO, move the motion-control levers to
the neutral-locked position and set the parking brake.
3. Locate and remove the spark plugs
A
g027478
Checking the Spark Plug
Important: Never clean the spark plug(s). Always
replace the spark plug(s) when it has: a black coating,
worn electrodes, an oily film, or cracks.
If you see light brown or gray on the insulator, the engine is
operating properly. A black coating on the insulator usually
means the air cleaner is dirty.
Set the gap to 0.76 mm (0.030 inches).
®
BPR4ES or equivalent
(Figure
47).
g015124
B
Figure 47
A
36
B
g027479
Figure 48