Toro 74142TE Operator's Manual page 27

Figure 33
1. Z Stand (Positioned in
slot)
2. Crack in side walk or turf
4. Set the foot of stand on the ground and rest the latch
on the pivot tab (Figure
5. Start the engine and put it at half throttle.
Note: For best results, place the foot of stand into
seams in sidewalks or into the turf
6. Drive onto the stand. Stop when the latch drops over
the tab into the locked position
onto the stand, engage the parking brake and tun off
the engine.
7. Chock or block the drive wheels.
WARNING
Parking brake may not hold machine parked
on Z Stand and could cause personal injury
or property damage.
Do not park on Z Stand unless wheels are
chocked or blocked.
8. Perform the maintenance.
Driving off the Z Stand
1. Remove the chocks or blocks.
2. Raise the latch to the unlocked position
Figure 34
1. Z Stand
2. Latch
3. Latch resting on pivot tab
33).
(Figure 33).
(Figure 33). Once
(Figure 34).
3. Locked position
4. Unlocked position
3. Start the engine and place it at half throttle. Disengage
the parking brake.
4. Slowly drive backwards off of the stand.
5. Return the stand to its rest position
27
(Figure 32).