Drive System Maintenance; Adjusting The Shift Cables; Adjusting The High-Low Cable; Adjusting Differential Lock Cable - Toro Workman HD 07369 Operator's Manual

•
If corrosion occurs at terminals, remove the battery
cover, disconnect the cables (negative (–) cable first), and
scrape the clamps and terminals separately. Reconnect
the cables (positive (+) cable first) and coat the terminals
with petroleum jelly.
•
If you store the machine in a location where temperatures
are extremely high, the battery will run down more
rapidly than if the machine is stored in a location where
temperatures are cool.
Drive System
Maintenance

Adjusting the Shift Cables

Service Interval: After the first 10 hours
Every 200 hours
1. Move shift lever to the Neutral position.
2. Remove the clevis pins securing the shift cables to the
transaxle shift arms (Figure 46).
1. Shift arm (1st–Rev.)
2. Shift arm (2nd–3rd)
3. Loosen the clevis jam nuts and adjust each clevis so
cable free play is equal forward and backward relative
to the hole in the transaxle shift arm (with the transaxle
lever free play taken up in the same direction).
4. Install the clevis pins and tighten the jam nuts when
finished.
Adjusting the High–Low Cable
Service Interval: Every 200 hours
1. Remove the clevis pin securing the High–Low cable to
the transaxle (Figure 46).
2. Loosen the clevis jam nut and adjust the clevis so that
the clevis hole aligns with the hole in the transaxle
bracket.
3. Install the clevis pin and tighten the jam nut when
finished.
Adjusting Differential Lock
Cable
Service Interval: Every 200 hours
1. Move the differential lock lever to the Off position.
39
Figure 46
3. Shift arm (High–Low)