Toro Workman HD 07369 Operator's Manual page 47

make sure the machine used to jump the hydraulic
system uses an equivalent fluid.
2. On both machines, disconnect the 2 quick coupler
hoses from the hoses secured to the coupler bracket
(Figure 65).
Figure 65
1. Quick coupler hose A
2. Quick coupler hose B
3. On the disabled machine, connect the two jumper
hoses to the hoses that were disconnected (Figure 66).
4. Cap the unused fittings.
Figure 66
1. Disconnected hoses
5. On the other machine, connect the two hoses to the
coupler still in the coupler bracket (connect the top
hose to the top coupler and the bottom hose to the
bottom coupler) (Figure 67).
6. Cap the unused fittings.
2. Jumper hoses
1. Jumper hoses
7. Keep all bystanders away from the machines.
8. Start the second machine and move the lift lever to the
raise position which will raise the disabled box.
9. Move the hydraulic lift lever to the neutral position and
engage the lift lever lock.
10. Install the bed safety support onto the extended lift
cylinder. Refer to Using the Bed Safety Support.
Note: With both the machines turned off, move the
lift lever back and forth to remove the system pressure
and ease the disconnection of the quick couplers.
11. After completing the operation, remove the jumper
hoses and connect the hydraulic hoses to both
machines.
Important: Check the hydraulic fluid levels, in
both machines, before resuming operation.
47
Figure 67