Toro Workman HD 07369 Operator's Manual page 27

CAUTION
Hydraulic fluid escaping under pressure can
have sufficient force to penetrate skin and do
serious damage. Care must be used when
connecting or disconnecting hydraulic quick
couplers. Stop the engine, apply the parking
brake, lower the attachment, and place the
remote hydraulic valve in the float detent
position to relieve hydraulic pressure before
connecting or disconnecting quick couplers.
Connecting the Quick Couplers
Important: Clean dirt from quick couplers before
connecting. Dirty couplers can introduce contamination
into the hydraulic system
1. Pull back the locking ring on the coupler.
2. Insert the hose nipple into the coupler until it snaps
into position.
Note: When attaching remote equipment to the quick
couplers, determine which side requires pressure, then attach
that hose to quick coupler B which will have pressure when
the control lever is pushed forward or locked in the On
position.
Disconnecting the Quick Couplers
Note: With both the machine and attachment turned off,
move the lift lever back and forth to remove the system
pressure and ease the disconnection of the quick couplers.
1. Pull back the locking ring on the coupler.
2. Pull the hose firmly from the coupler.
Important: Clean and install the dust plug and
dust covers to the quick coupler ends when not
in use.
27