Operation; Settings And Functions; Electronic Temperature Settings; Key Press Confirmation - Viking FDSB5481 Service Manual

Operation

Settings and Functions

Power On/Off Switch (Power Interruption
Switch) The power on/off switch is located
behind your refrigerator's top grille. It is used
to turn the power "OFF" when cleaning the
refrigerator or changing the light bulbs. Your
refrigerator arrives from the factory with the
power interruption switch "ON".
To turn power "OFF", remove the center grille
blade. Press the power on/off switch to the
"OFF" position.
To turn power "ON", press power on/off switch
to the "ON" position. Replace the center grille
blade.
IMPORTANT: Be sure the power on/off
switch is in the "ON" position after cleaning or
changing light bulbs.

Electronic Temperature Settings

Your refrigerator's electronic controls are
located behind the door above
the cabinet interior. To activate
the electronic control panel,
press "ACTIVATE CONTROLS"
pad. All other pads, except the "Alarm Off"
pad, will remain inactive until the "ACTIVATE
CONTROLS" pad is pressed. Once activated,
pad remains programmable for at least ten
minutes
6
Electronic Temperature Settings
When power is first applied to the refrigerator,
there will be two dashes
displayed as in illustration.
After approximately thirty
seconds the digital display
will change to numbers,
indicating temperature in the refrigerator
(default upon initial start-up) compartment
along with the word REFRIGERATOR and
degrees Fahrenheit.
To adjust temperature , enable
the key pad controls by pressing
and releasing the "ACTIVATE
CONTROLS" pad. Select "REF
TEMP" or "FRZ TEMP" pad
for applicable section. The
temperature is then
adjusted in that section
by pressing "HIGHER
or LOWER" pad while
observing digital readout.

Key Press Confirmation

The key press confirmation is the "beep" that
is heard when a control pad is pressed. This
audible confirmation can be made active or
inactive.
To deactivate the confirmation
beep press and hold "ACTIVATE
CONTROLS" pad for three seconds,
ACTIVATE
CONTROLS
three long beeps will be heard, confirming
deactivation.
To activate the confirmation beep press and
hold "ACTIVATE CONTROLS" pad for three
seconds, three long beeps will be heard,
confirming activation.
ACTIVATE
CONTROLS
FRZ
TEMP
HIGHER LOWER
ACTIVATE
CONTROLS
©2012 Viking Preferred Service